Canarina software for analysis of air pollution in environment: environmental engineering, environmental consultancy service, environment simulation, environmental modeling and environmental impact assessment.

Canarina home - Air pollution dispersion · DISPER - Noise pollution · CUSTIC - Water pollution · DESCAR - Contact us - DEMO download

Air pollution dispersion · DISPER - Software solutions - Software advantages - Price - Input data I - Input data II - Input data III - Input data IV - Average - Import data - Software commands - Math. algorithms I - Math. algorithms II - Math. algorithms III - Math. algorithms IV - Math. algorithms V - Emissions - Pollutants I - Pollutants II - Graphs I - Graphs II

                 

DEMO Download

 

Example 1:

Both XY-Calculation and XZ-Calculation have been used in our simulation. In this way, the physical form of the pollutant plume can be obtained. Calculation in both XY-plane (parallel to ground surface) and XZ-plane (perpendicular to ground surface). The fucshia square represents a point source (stack). The red colour represents high pollutant concentrations. Pollution map of Nitrogen oxides (NOx) produced by en industrial stack. The wind angle is 45 degrees (NE), the wind velocity is  5 m/s and the pollutant flow rate is 1g/s. The fucshia square represents the point source (position of the stack).  We have a three-dimensional image of the pollutant plume with these two computer screens.

 

 

Pollution map produced by continuous discharge in this region. Top: the orange horizontal line indicates us the position of the XZ-Plane. Bottom: The fucshia line  represents a point source (stack). The red colour represents high pollutant concentrations.

 

Example 2:

Both XY-Calculation and XZ-Calculation have been used in our simulation. In this way, the physical form of the pollutant plume can be obtained. Calculation in both XY-plane (parallel to ground surface) and XZ-plane (perpendicular to ground surface). The fucshia squares represent three point sources (stacks). The red colour represents high pollutant concentrations. Pollution map of Nitrogen oxides (NOx) produced by en industrial stack. The wind angle is 0 degrees (N), the wind velocity is  5 m/s and the pollutant flow rate is 1g/s. The fucshia squares represent the point sources (position of the stacks).  We have a three-dimensional image of the pollutant plume with these two computer screens.

 

 

Pollution map produced by continuous discharge in this region. Top: the orange horizontal line indicates us the position of the XZ-Plane. Bottom: The fucshia line  represents a point source (stack). The red colour represents high pollutant concentrations.

 

Graphs I - Graphs II

 

Canarina Algoritmos Numéricos, S.L.

Environmental software solutions

                    

                          

Canary Islands, Spain

e-mail: info1@canarina.com

 

 

 

European network on pollution · European Union

Member of MAPO: European network on Marine Pollution. Project

funded by the European Commission through the

6th Framework Programme for Research and Development

 

                 

Air pollution dispersion · DISPER - Software solutions - Software advantages - Price - Input data I - Input data II - Input data III - Input data IV - Average - Import data - Software commands - Math. algorithms I - Math. algorithms II - Math. algorithms III - Math. algorithms IV - Math. algorithms V - Emissions - Pollutants I - Pollutants II - Graphs I - Graphs II

 

Copyright © 2005 Canarina Algoritmos Numéricos, Sociedad Limitada Unipersonal CIF-B38803110 registered for electronic commerce in sheet TF-35526, sheet 1 of the volume 2.671 of the General Section, First Registration, Registro de la Propiedad Número 2 y Marcantil of , Spain. All rights reserved.